Leitz 5008 Hole Puncher Gridfinity Drawer clamp
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a gridfinity holder for the hole puncher Leitz 5008 which holds it tight to fit inside a drawer
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 19
- Wydruki
- 1
- Wyświetlenia
- 299
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
This is a gridfinity “bin” for the hole puncher Leitz 5008.
Due to the low height of my drawer, the puncher can not be stored in its full height. Therefore, this part acts as a clamp, forcing the puncher to be closed a little bit.
I placed the part intentionally not aligning perfectly to the bottom gridfinity base, but slightly shifted to have room for the alignment strip.
Additionally: You need some space in front to allow the puncher to be slotted in and out.
My first idea was to print it with a stopper in front, but this was not necessary, so the following draft did not made it into the final print.
Print instructions
Printed in black PETG.
I decided to cut the part in the slicer in half and print only the back part of it, lying on the back itself. This is the part I share here as stl file. The whole assembly is not tested, but can be found in onshape: onshape document
With this print orientation, the gridfinity base needs some small organic support.