Titex Calibrated Powerlifting Barbell and Plates 0.25kg to 25kg plates with collars
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
1/5 scale replica of a Titex Calibrated Weight Plate set
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 69
- Wydruki
- 0
- Wyświetlenia
- 381
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Indoor Sports
- Licencja
- Creative Commons — Public Domain
This is my attempt at replicating a 1/5 scale model of a Titex Calibrated Weight Plate set. Everything can be printed, however I found that the plates were too heavy for a printed barbell. Use a 6mm x 300mm aluminum rod in place of the actual bar. You can get them on Amazon really cheap. Barbell sleeves are snug enough for a press fit on the aluminum rod, although you may need to sand the rod a bit to get them on initially. The collars come in three parts. Make sure you print out two end caps for every collar. Cut a piece of filament to use as the tightening handle, and glue the end caps on to the ends of the filament.
Plate holes have a very tight tolerance to the barbell and may be difficult getting on at first, however, sliding each plate on and off a few times loosened it up to a perfect fit. If you use an aligned Z seam on everything, you can get the collars to lock in place with a bit of a twist.
The plates have a great feel if you use 100% infill. I think I also went with a .15mm layer height. No brim is needed as the plates are round.
I've also made a 1/5 scale ER Combo Rack that is intended to go along with the plate set, but that is not included here. You can find that model in the link below.
https://www.printables.com/model/1193394-15-scale-model-of-an-er-combo-rack-for-powerliftin
Note: For the Collar Screw and Collar Screw End Caps I've found that I can print them just fine on my Prusa MK4S, but my friend can't get it to print at all with a 0.4 nozzle at all on his Ender. He can however make it work with a 0.25 nozzle just fine so keep that in mind.
