1 / 4
FPV Battery Holder (for CNHL Speedy Pizza v2 4S/600mAh) — zdjęcie 1
1 / 4

FPV Battery Holder (for CNHL Speedy Pizza v2 4S/600mAh)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Simple, quick, easy-to-print battery holder/case for FPV drone batteries (designed for CNHL Speedy Pizza v2 4S 600mAh)

Ocena
0 / 5
Polubienia
1
Pobrania
11
Wydruki
0
Wyświetlenia
65
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a simple FPV drone battery holder/case. It keeps up to 3 batteries securely together while covering the battery connectors.

Battery model: ChinaHobbyLine Speedy Pizza v2 120C 4S 600mAh LiPo

The batteries are held in place by friction; however, the fit may vary depending on the tolerances. For me, the batteries stay in even when shaking the holder as hard as I can, yet they are still easy to push in with little effort.

Instructions

Material: Does not matter. I used PETG, but basically any filament should work.

Printing: Print upright with the flat bottom on the build plate (no supports are needed).

Use: Push battery in bottom-first, making sure it's the correct way around. Push the larger balance connector into its slot and the smaller XT30 connector into its slot. There you go!

 

Tagi