FPV Battery Holder (for CNHL Speedy Pizza v2 4S/600mAh)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple, quick, easy-to-print battery holder/case for FPV drone batteries (designed for CNHL Speedy Pizza v2 4S 600mAh)
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 11
- Makes
- 0
- Views
- 65
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a simple FPV drone battery holder/case. It keeps up to 3 batteries securely together while covering the battery connectors.
Battery model: ChinaHobbyLine Speedy Pizza v2 120C 4S 600mAh LiPo
The batteries are held in place by friction; however, the fit may vary depending on the tolerances. For me, the batteries stay in even when shaking the holder as hard as I can, yet they are still easy to push in with little effort.
Instructions
Material: Does not matter. I used PETG, but basically any filament should work.
Printing: Print upright with the flat bottom on the build plate (no supports are needed).
Use: Push battery in bottom-first, making sure it's the correct way around. Push the larger balance connector into its slot and the smaller XT30 connector into its slot. There you go!