Autel VCMI+ EVDiag Box Handle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Snap-fit Handle for the Autel MaxiFlash VCMI + EVDiag Box
- Ocena
- 5 / 5
- Polubienia
- 4
- Pobrania
- 52
- Wydruki
- 1
- Wyświetlenia
- 228
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
My main goal for a handle was that i could mount and dismount it without destroying or drilling a hole in the VCMI. Despite that Snap-fit design it has plenty of grip on the VCMI.
To accomplish that grip i did make it pretty tight. So pleas make a test print
( around 5mm ) to check the fit and adjust the scale if necessary.
Printing:
- Material: Pla/Pla+ is enough
- Perimeters: at least 3 Walls
- Infill: ~25%
- Support: classic support for the handle connection
- Orientation: the round handle should be vertical that the layerlines not splitting apart while installing.
Installation:
Place your VCMI on the side with the handle/bigger tap (see Picture), now you should be able to bend the smaller tap over your VCMI.
Don't give up, after the first installation you should know how it works ;-)
Edit: I did add a Handle for the EV Diagnostic Box (Breakout Box for EV components). Printsettings and Installation is the same
Update:
V2 for the VCMI is more suitable for high heat. the standard version did bend itself after a long summer day in a car. but be careful it is harder to install and impossible to remove without unscrew a side Panel due to a stiffer design