VH31 to NH35 Movement Spacer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A movement spacer that allows a VH31 movement to fit within the most common NH35 cases.
- Ocena
- 0 / 5
- Polubienia
- 30
- Pobrania
- 649
- Wydruki
- 0
- Wyświetlenia
- 2504
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
This movement spacer allows a VH31 movement to fit within the most common NH35 cases.
The files are upside-down, so please flip them over in the slicer before printing :)
The movement spacer also has holes for NH35 dial feet, so you do not have to snip them off. If your dial has extra feet in addition to the NH35 ones, those will have to be snipped off.
When printing the spacer, the holes may close up due to their small diameter. To account for this, the diameter of the dial feet holes are 1mm, which are significantly larger than the feet's .65mm diameter. If it is too loose, adjust the horizontal expansion for holes.
Additionally, the hole the VH31 sits in may also have to calibrated so that it fits snug, but not too tight.
It is ok if the dial or movement are slightly loose when assembling. In fact, it may even be beneficial as it makes the watch easier to disassemble in the future. This is because everything will stop moving anyway by the time the case back is put on.