Thrustmaster Joystick Grip Adapter (20mm square tube) - FFBeast
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapter for Thrustmaster Grip to 20mm square tube. Option for FFBeast or similar with cheap extension.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 51
- Wydruki
- 0
- Wyświetlenia
- 501
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Means to create a Thrustmaster/Similar joystick extension with cheap 20mm square tube.
Prints in two halves to allow addition of 5 pin mini din cable (pictured) to pass through before adding to the tube. Holes on the sides can be tapped for screws (or the tube itself can be).
I specifically designed this for an FFBeast joystick. Due to the high forces you will need a strong 3D print, I have tried PLA+ (sheared off after a few days use), ABS (shattered after a few months in a violent stick movement). Finally had printed in SLM Stainless Steel by JLC3dp (like a rock now).
Should be fine with a filament print on less powerful force feedback joysticks or traditional spring based sticks, or with stick power dialed down.
I have included both straight on and 15 degree offset parts.