Replacement brake block for Moza SRP Pedals
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement block to hold the spring stack on the SPR brake pedal. I stripped the thread on the original...
- Ocena
- 0 / 5
- Polubienia
- 20
- Pobrania
- 124
- Wydruki
- 0
- Wyświetlenia
- 1256
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution
After rescrewing the rod on the SRP brake for the thousandth time, I finally stripped the thread with some excessive force. Here's a replacement I quickly modelled up.
Before you're worried, all the braking force will be handled by the rod you see in pic. 2.
Lines: 0.6mm*0.15mm (0.4mm nozzle)
Infill: 18% cubic?
Screw the original rod into the hexagon to form a full thread. Use a pipe wrench gripped close to the hinge (or a 3.8mm spanner apparently). Don't play with the thread afterwards, it will just get worn loose again.
With the thread being formed by the rod itself, and the washer being integrated, I think it stays put better than the original XD.
WARNING:
Only use die springs for this model, or other springs with a completely flat bottom. I replaced my broken spring with a round profile while waiting for the real replacement, the round bottom and smaller profile went through within a month. The new heavier die spring is still good after 6 months of use.