Replacement brake block for Moza SRP Pedals
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement block to hold the spring stack on the SPR brake pedal. I stripped the thread on the original...
- Rating
- 0 / 5
- Likes
- 20
- Downloads
- 127
- Makes
- 0
- Views
- 1,271
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution
After rescrewing the rod on the SRP brake for the thousandth time, I finally stripped the thread with some excessive force. Here's a replacement I quickly modelled up.
Before you're worried, all the braking force will be handled by the rod you see in pic. 2.
Lines: 0.6mm*0.15mm (0.4mm nozzle)
Infill: 18% cubic?
Screw the original rod into the hexagon to form a full thread. Use a pipe wrench gripped close to the hinge (or a 3.8mm spanner apparently). Don't play with the thread afterwards, it will just get worn loose again.
With the thread being formed by the rod itself, and the washer being integrated, I think it stays put better than the original XD.
WARNING:
Only use die springs for this model, or other springs with a completely flat bottom. I replaced my broken spring with a round profile while waiting for the real replacement, the round bottom and smaller profile went through within a month. The new heavier die spring is still good after 6 months of use.