Sony 70-350mm Lens Collar
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Printable lens collar for a Sony 70-350mm lens.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 192
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution
IMPORTANT!! PRINT AND USE AT YOUR OWN RISK!!
Please understand that this is a cheap piece of plastic that will be used to hold at least 1k worth of equipment. Use at your own risk.
I saw that lens collars for this specific lens are about $50, so I made my own. This is designed for a Sony E 70-350mm f/4.5-6.3 G camera lens.
The 'tripod quick shoe' mount was designed with a Fotopro tripod in mind, but the screw hole on the bottom is just a standard 1/4-20 thread, so it might be able to fit others.
The whole thing is tightened by a 1/4" replacement knob I found at Lowe's, which is linked below. You will need some washers as well, I linked the ones I used.
Don't tighten the ring to tight btw :)
Parts used:
Knob, 1/4-20 threading: https://www.lowes.com/pd/Hillman-Replacement-Knobs/4757889
Washers: https://www.lowes.com/pd/Danco-10-Pack-1-2-Rubber-Washer/3380002
Slip a washer on the knob before putting it in the part, this will allow the ring to be tightened.
Print Info:
I printed this on PETG for its strength and UV resistance properties. Printed with higher infil percentage (30-40%).