Catcher for seat side pocket 2009-2016 Prius.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Make use of that small space beside the seat and the door in your car.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 381
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
There is a space on the floor beside the seat and the door on a Prius (I have a gen3) and it would be a great place to store something liker an ice scraper or gloves, except that whatever you put in it will roll under the seat to disappear until you accelerate hard (unlikely) or do a deep clean.
The intent of this print is to prevent the rollaway from happening. Attach some hook Velcro and slide it into place. It isn't quite the full length of the space, I measured about 240 mm and made it 220 mm, but that isn't too much gap, and the “load” shelf is about ⅔ the actual distance between the door well and the seat rail, but you can position it where you like. There is a pair of built in gussets on the under seat side for support (not likely necessary, but there.) And traction indents on the load side to reduce sliding of items.
If you find it useful, please post and review.
It will easily print on a 220x220 bed and could fit in as small as 190x190x70 build volume as is if printed on the diagonal.
Printed in PET-G for now, and I recommend ASA/ABS if it gets too soft in the summer months, don't bother with PLA inside a car unless you live north of 50 N Latitude (or in Tierra del Fuego.) No supports are necessary.