Stable Original Prusa Enclosure RepBox 2.5 Stand

This model is heavily based on the Original Prusa Enclosure RepBox 2.5 Stand by techis, which is, in turn, heavily based on the RepBox stands from Kyle and MakoDaShark. 

Updates:

• 2024-04-01: Added two optional posts for the back of the enclosure that can provide some additional stability under the very back end of the dry box.

To make use of this model, you will need:

• 1 Original Prusa Enclosure (with or without the hinged lid)
• 1 (Un)original Prusa Drybox that has been assembled with the following 
  “optional” parts:
  • Beam C1_(RB)(20mm)
  • Beam C2_(RB)(20mm)
• 6 (hinged lid Prusa enclosure) or 8 (sealed lid Prusa enclosure) M3x12 screws
• 6 (hinged lid Prusa enclosure) or 8 (sealed lid Prusa enclosure) M3 nuts
• and if you use the optional posts for the back of the enclosure, you will need 4 M3x16 screws.

I highly recommend printing the part of the model below the two posts with 100% infill, as it will make that part much more robust and less likely to break if you are going to be removing and attaching the dry box a lot over time. The posts up to the top should do just fine with a 15% gyroid infill. The repbox_stand_2_5_stable_PROJECT.3mf file is a PrusaSlicer project and already has a modification set up for each object to handle this for you.

MAKERS: Please post a picture with comments here of any prints/makes you do from this model so that I can see how people are using it and whether you are finding success with it. Thanks!

This is a comparison between this remix and the original stand that it is based on:

This is a photo of one of the C (RB) Beams that your (Un)Original DryBox should be using. You can print two new C beams from the DryBox model files if necessary.