Panel Wire Grommet With Slotted Opening - 1/2 inch thick, 3/4 inch long - with end cap nuts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I recently made an antenna connector passthrough panel for my window. I needed a 1/2" hole on one side of the panel…
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 39
- Wydruki
- 0
- Wyświetlenia
- 393
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
I recently made an antenna connector passthrough panel for my window. I needed a 1/2" hole on one side of the panel and wanted to make a grommet that I could slide cables into that would stay put inside the hole. I ran my antenna wires through the slot that is cut out and stuffed some foam inside with the wires to create a weather seal from the outside.
It's for a 1/2" hole through a panel that is 3/4" thick.
UPDATE: I have added two files as an update. I tried to make the same type of setup, but with a bolt split in half for more strength.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
No
Supports:
No
.20
Infill:
20%
Notes:
Probably wouldn't hurt to put a skirt on the middle bolt part. There isn't much sticking to the bed. I had no issues, but if you do, add a skirt.
Category: Parts