1 / 9
HomeLab Rack Side Brace and 1U Blanking Plate — zdjęcie 1
1 / 9

HomeLab Rack Side Brace and 1U Blanking Plate

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Wstępna wycena dla PETG

5,29 € – 6,46 € netto (bez VAT)

Dla pliku: Rack Side Brace v4_0.2mm_PETG_MK3S_5h28m.gcode

To wstępna wycena jednego pliku. Dokładną cenę poznasz przed zamówieniem.

Plik i założenia wyceny

Plik użyty do wyceny

Średnia wycena orientacyjna: 5,87 € netto (środek widełek).

Masa podana przez autora
88 g
Czas druku podany przez autora
5,46 godz.
Materiał u źródła
PET
Materiał wyceny
PETG
Drukarka wyceny
Bambu Lab P1S - 0.4 nozzle
Proces wyceny
0.20mm Standard

Orientacyjna wycena wyłącznie wybranego pliku, oparta na masie i czasie druku podanych przez autora. Warianty plików nie są sumowane. Ostateczna cena zostanie obliczona po analizie pliku.

Zapisane na tym urządzeniu.

Side braces to create your own homelab rack using standard rack rails, also has some blanking plates

Ocena
0 / 5
Polubienia
6
Pobrania
24
Wydruki
0
Wyświetlenia
407
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Building my own homelab and just purchased the rack rails to 3d print my own components - Created these side braces to make a rack that is a little over 250mm deep to sit on my desk.

I've fastened these to the rails with M5 bolts, a small washer and a nut and the depth is perfect so as not to block the rack mount points.  Standard racks have screw holes 44.45mm centre to centre apart and these braces match perfectly.

There is extra support from the levelling on the plate to use the straight edge of the rail to hold against.

In theory it'd work to create a 10 or 19 inch rack.

Printing just about gets two on the plate using a MK3S+, but without any brim etc.

 

09-04-2025 - Added Blank Plate for 10" rack

 

 

 

Tagi