1 / 9
HomeLab Rack Side Brace and 1U Blanking Plate — image 1
1 / 9

HomeLab Rack Side Brace and 1U Blanking Plate

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Side braces to create your own homelab rack using standard rack rails, also has some blanking plates

Rating
0 / 5
Likes
6
Downloads
24
Makes
0
Views
407
Reviews
0

Updated at source:

Model information

Category
Computers
License
Creative Commons — Attribution — Noncommercial — Share Alike

Building my own homelab and just purchased the rack rails to 3d print my own components - Created these side braces to make a rack that is a little over 250mm deep to sit on my desk.

I've fastened these to the rails with M5 bolts, a small washer and a nut and the depth is perfect so as not to block the rack mount points.  Standard racks have screw holes 44.45mm centre to centre apart and these braces match perfectly.

There is extra support from the levelling on the plate to use the straight edge of the rail to hold against.

In theory it'd work to create a 10 or 19 inch rack.

Printing just about gets two on the plate using a MK3S+, but without any brim etc.

 

09-04-2025 - Added Blank Plate for 10" rack

 

 

 

Tags