1 / 7
Y Connector housing for barrel connectors
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Y connector (splitter) housing to contain all the interconnect wires on barrel adapters
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 81
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a Y connector (splitter) for barrel connectors commonly used in low voltage applications.
My goal was to conceal the wires. I mounted this with magnets onto my blast cabinet to provide a place to plug in my drying fans.
Mounting holes are 6mm for my application. I provide some hole reducers if needed.
Designed to accommodate up to 18ga wire.
Two Models
- Offset: The objective was to reduce the overall length front to back. This makes the unit taller as the wires will need to run through tunnels underneath.
- In_Line: Simple front to back. This makes for a very long unit when all the plugs are attached. The gap ended up around 15mm.
Printing Instructions
- I only tested with PETG
- No Supports needed
- Lids were designed to print top down on the plate for layer strength
Assembly
- Note the recommendations in the photos for Wiring.
- Slide the lid into the grove from the mail connector side.