1 / 7
Y Connector housing for barrel connectors — image 1
1 / 7

Y Connector housing for barrel connectors

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Y connector (splitter) housing to contain all the interconnect wires on barrel adapters

Rating
0 / 5
Likes
2
Downloads
8
Makes
0
Views
81
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial

This is a Y connector (splitter) for barrel connectors commonly used in low voltage applications.

My goal was to conceal the wires.  I mounted this with magnets onto my blast cabinet to provide a place to plug in my drying fans.

Mounting holes are 6mm for my application.   I provide some hole reducers if needed.

Designed to accommodate up to 18ga wire.

Two Models

  1. Offset: The objective was to reduce the overall length front to back.  This makes the unit taller as the wires will need to run through tunnels underneath.
  2. In_Line:  Simple front to back.  This makes for a very long unit when all the plugs are attached.  The gap ended up around 15mm.

Printing Instructions

  • I only tested with PETG
  • No Supports needed
  • Lids were designed to print top down on the plate for layer strength

Assembly

  • Note the recommendations in the photos for Wiring.
  • Slide the lid into the grove from the mail connector side.

 

Tags