1 / 5
PILLY! 7 Days. The convenient daily medication dispenser. — zdjęcie 1
1 / 5

PILLY! 7 Days. The convenient daily medication dispenser.

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Get organized with this convenient medication carousel. 7 slots for every day of the week. And with a satisfying click!

Ocena
5 / 5
Polubienia
16
Pobrania
82
Wydruki
3
Wyświetlenia
702
Oceny
3

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

After many iterations and design changes i’m happy to release: 

PILLY! the 7 day medication organizer.


Designed around a central gear with a print-in-place clicky mechanism that snaps the lid into place above every compartiment with a satisfying CLICK! An ergonomically designed lid for ease of use. Each compartiment is labeled with weekday abbreviations and comes in the following languages:

  • Dutch
  • English

I can do other languages if requested.

I was inspired by the OREO pill organizer by Lehadesign over on thangs, but i needed something more for my wife’s medication.

No scews needed, but i would recommend a tiny bit of superglue to attach the gear to the top lid.
The gear has a female slot wich can be paired with the top lid, this way the cut-out in the lid is perfectly alligned with each of the compartiments. PAY ATTENTION! Before glueing, first dry-fit the lid and make sure the cut-out is alligned with one of the compartiments, if not, twist 180 degrees! You can also glue the BOTTOM LID to the PILL TRAY but make sure not to get glue inside the space for the gear, as it needs to rotate freely.

I've made an assembly video on YouTube:

Print orientations:

BOTTOM  LID can be printed bottom down with no supports.

PILL TRAY needs to be printed with the compartiments visible (logically) and may need supports depending on your printer.

GEAR needs to be printed with the female slot up, i printed it with no supports, no problems.

TOP LID needs to be printed top-side down, no supports needed

 

Layer height: .2mm

Infill: 15-20%

Material: PLA+ (recommended), PLA

Tagi