Mandala Roseworks V-Core 3.1 Z Motor Mount Trim Pieces
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Depending on the foam & bottom enclosure thickness, these printed parts can take up extra space to seal the chamber.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 95
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
These help better seal your chamber in a V-Core 3.1 with the Mandala Roseworks Z Motor Mounts (which you can purchase here: https://mandalaroseworks.com/products/ratrig-z-motor-mount-for-vcore-3-1).
For the trim pieces that go under the Z motor mounts, I sized the printed parts expecting that the foam underneath them is 3mm thick (and will compress some when installing the metal motor mounts). If you use thicker or thinner foam, then adjust the printed part accordingly (STEP files provided).
For the Front Panel Trim Pieces, the section that sits between the Z motor mount and the lower corner plate is very, very thin. You might need to print several as I did snap a few while installing them. They are quick and easy to print. I then put 1mm thick foam on these after installing them to help them better seal against the front panel.