1 / 6
Borg Cube geocache remix
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution
A better attempt at the borg cube geocache since the initial version got muggled.
this one turns out well
Print instructions
Print Settings
Printer Brand: MK3
Printer: Prusa i3
Rafts: Yes
Supports: No
Resolution: 200
Infill: 15
Notes:
I used abs and therefore a 20mm brim to hold it down
The magnets are 10x2mm and they do a good job of holding it, however you may need to file the top of the magnet area down as i did to get it to fully close.
if you do print in abs, the top and bottom are "glued" on with acetone. the bottom you see is a couple of bux at walmart and will weld the parts together so make sure you get it on right the first time.