1 / 6
Borg Cube geocache remix
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution
A better attempt at the borg cube geocache since the initial version got muggled.
this one turns out well
Print instructions
Print Settings
Printer Brand: MK3
Printer: Prusa i3
Rafts: Yes
Supports: No
Resolution: 200
Infill: 15
Notes:
I used abs and therefore a 20mm brim to hold it down
The magnets are 10x2mm and they do a good job of holding it, however you may need to file the top of the magnet area down as i did to get it to fully close.
if you do print in abs, the top and bottom are "glued" on with acetone. the bottom you see is a couple of bux at walmart and will weld the parts together so make sure you get it on right the first time.