1 / 2
Creality K1 Max - Top Spool Holder w/ bearings (for printing TPU) — zdjęcie 1
1 / 2

Creality K1 Max - Top Spool Holder w/ bearings (for printing TPU)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A top mounted filament spool holder for printing TPU on a K1 MAX. Uses bearing roller to reduce strain on filament.

Ocena
4,667 / 5
Polubienia
40
Pobrania
403
Wydruki
2
Wyświetlenia
2070
Oceny
3

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Top mounted filament spool holder. Used for printing TPU on a K1 MAX.

The adapter rings are a press fit into the original side supports to adapt them to fit standard cartridge bearings. The spool roller should be a slip fit into the inner bearing races so it can easily come apart to install the filament roll. 

Since the bearings are a slip fit, the structure is less rigid than the original design, so I added spring clamps to secure the the side supports to the printer frame. 

I recommend "cutting" the roller into 3 sections but leaving them assembled as one roller. Print each end that slides into the bearing race at 100% infill for strength. Print the middle section at lower infill to save time/filament.

I have adapter ring and spool roller files for the following bearing sizes:

6200 bearings (10 mm ID x 30mm OD x 9mm wide)

6002 bearings (15mm ID x 32mm OD x 9 mm wide)

608 bearings (8mm ID x 22mm OD x 7 mm wide)