1 / 2
Creality K1 Max - Top Spool Holder w/ bearings (for printing TPU) — image 1
1 / 2

Creality K1 Max - Top Spool Holder w/ bearings (for printing TPU)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A top mounted filament spool holder for printing TPU on a K1 MAX. Uses bearing roller to reduce strain on filament.

Rating
4.667 / 5
Likes
39
Downloads
397
Makes
2
Views
2,027
Reviews
3

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Top mounted filament spool holder. Used for printing TPU on a K1 MAX.

The adapter rings are a press fit into the original side supports to adapt them to fit standard cartridge bearings. The spool roller should be a slip fit into the inner bearing races so it can easily come apart to install the filament roll. 

Since the bearings are a slip fit, the structure is less rigid than the original design, so I added spring clamps to secure the the side supports to the printer frame. 

I recommend "cutting" the roller into 3 sections but leaving them assembled as one roller. Print each end that slides into the bearing race at 100% infill for strength. Print the middle section at lower infill to save time/filament.

I have adapter ring and spool roller files for the following bearing sizes:

6200 bearings (10 mm ID x 30mm OD x 9mm wide)

6002 bearings (15mm ID x 32mm OD x 9 mm wide)

608 bearings (8mm ID x 22mm OD x 7 mm wide)