Dial gauge holder for Prusa MINI
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Dial gauge holder for Prusa MINI, holding shaft diameter of 8 mm
- Ocena
- 5 / 5
- Polubienia
- 19
- Pobrania
- 140
- Wydruki
- 1
- Wyświetlenia
- 1864
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This dial gauge holder is screwed to the heat sink with a M3x10 screw. Dial gauges with a shaft diameter of 8 mm can be clamped with it. Without the dial gauge mounted, the holder does not interfere with mesh bed leveling or homing.
Tip for use: After mesh bed leveling, the firmware attempts to compensate for the deviations determined by moving the Z axis when moving the X and Y axes. A NEMA (extruder) motor rotation indicator on the Z-axis motor helps to detect this.
If you want to avoid that the firmware corrects with the Z-axis, you should only perform an XY homing after switching on the printer.
Please take a look at my feet for the Mini.