ER Collet Factory (ER8 thru ER32)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
CadQuery customizable ER Collet factory for any collet hole size in ER8, ER11, ER16, ER20, ER25, or ER32.
- Ocena
- 5 / 5
- Polubienia
- 37
- Pobrania
- 512
- Wydruki
- 1
- Wyświetlenia
- 1940
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
NOTE: This design is a WORK IN PROGRESS, I don't have any ER collet holders so I don't know how viable this design is. I take no responsibility for any accidents that may result from using these 3D models. ER Collets are often used on powerful machines that spin at high speeds, please be careful when using these 3D models or injury/death may result! I make NO warranty about the safety of these models. Also, the dimensions of the ER collets may not be very accurate.
This customizable 3d model was designed using CadQuery in the CQ-Editor GUI with a snapshot from April 13th 2022. You can customize this model in your web browser without installing anything using the excellent service from CadHub.xyz. You can specify any collet hole size (in the acceptable range) for any collet size (ER8, ER11, ER16, ER20, ER25, or ER32).
Customizable ER Collet Factory
Printing an ER Collet on an FDM machine is challenging because there are sharp overhangs. I printed the pictured collet with the flat side next to the long taper down.