K1 Max exhaust active charcoal pellet and hepa filter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Filter for the exhaust for the K1 max using a custom box for carbon pellets and a hepa filter
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 84
- Wydruki
- 0
- Wyświetlenia
- 631
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
This is a custom filter for the exhaust of the K1 max.
As the exhaust sold by Creality is a joke of a filter, I wanted to clean the air leaving the machine as much as I can.
The internal and external charcoal boxes are printed face down and the honeycomb pattern is created via the slicer (8 walls, no top/bottom and 10% honeycomb infill), so create the pattern size you need for the carbon you use.
The hepa filter is 100mm by 105mm and is a Ilife airfilter compatible like these :
Aliexpress Ilife V8 filter research
I added some kepton tape to the external cage and 2mm thick adhesive foam to the panel interface to really make the exhaust hold on to the back of the machine and to be airtight, I didn't want to play with the tolerances of the print, which can vary depending the material you want to use for this.
The inerant issue with this mod is as the exhaust fan tries to push air through the filter and no pull it, it's not as efficient as it could be. Installing a bigger and thicker fan like a 9238 could be a solution (that I will personnally try in the futur)
But the advantage that come with it is as it doesn't suck as much air out of the machine, which means that I even let it run at 50% even with ASA or ABS to be sure the air leaving the machine goes only through the filter but suck very little cold air from the room