1 / 1
Bolt for the  filament cutter 45° (instead of M3x25 screw) — zdjęcie 1

Bolt for the filament cutter 45° (instead of M3x25 screw)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This should make it possible to assemble the filament cutter without two M3x25mm screws

Ocena
5 / 5
Polubienia
27
Pobrania
220
Wydruki
1
Wyświetlenia
1256
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This saves you a trip to a hardware store and few cents on the M3x25 screw ;) 

I really liked the design of the filament cutter, but it required two M3x25 screws which I did not have. These screws were also unavailable in the nearest store… so I've printed two of those bolts, sanded them a bit and then with a little bit of force I've managed to assemble the cutter without any screws. 

Printed on the side with supports, PLA, 0.15mm layer height. Required a bit of sanding to fit the top part of the cutter.

Source file for Fusion 360 is included, but generally the design is extremely simple - the bolt's diameter is 2.6mm and the head's diameter is 4.8mm