EspressoBin HDD Storage Enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
If you happen to have an EspressoBin, and would like to use it as a storage pod, this might be all you need.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 467
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
I had two EspressoBins laying around and needed an enclosure. Lets you pair an 3.5" SATA drive with the SBC. Be aware that I have designed this around the first release of the EspressoBin (v5 I believe). If you have a v7 I can't guarantee that it'll fit.
The screw holes prints with threads, but the fit is a bit tight so I run through them with a tap before assembly. You also need to take a pair of flush cutters and snip away the supports between the ethernet ports.
In addition to the printed parts you need a SATA cable where at least one end needs to have a 90 degree angle.
You'll also need a power cable from the Molex connector on the SBC to the HDD. I had to combine two adapters to make it work.
Screws needed:
- 2 x M5: between 40 and 50mm long
- 4 x M5: 15 mm long
- 6 x 6-32 “computer” screws. These need to be approximately 10mm long
- 4 x M3: 4 mm long (for SBC)
Some small rubber dampeners for the feet also helps to avoid noice.