1 / 3
Prusa Core ONE Assembly Jigs (Unofficial)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple jigs to help with accurate assembly of the Prusa Core One
- Ocena
- 5 / 5
- Polubienia
- 135
- Pobrania
- 475
- Wydruki
- 27
- Wyświetlenia
- 3024
- Oceny
- 29
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 27) (Komentarze: 36)Remiksy (0)Kolekcje (319)Powiązane
Having done a full disassembly and reassembly of the Prusa Core without instructions I felt in a good position to provide some assembly jigs to help you when you decide to do the same, or just for maintenance etc.
X Rail Jig
- Print TWO pieces.
- Place the rail onto the gantry beam and lightly add all the screws allowing the rail to move.
- Place the jigs on, near the ends of the rail, avoiding the screw positions.
- With the jigs in place, tighten the screws.
- Remove the jigs.
Y Rods Jig
- Print TWO pieces
- Place the rods, gantry, and bearings all onto the gantry frame and lightly screw into place allowing some wiggle room.
- On the left side, add the jigs to each end of the rod, with the bearing in the middle.
- With the jigs in place, tighten the screws on the left side.
- Remove the jigs.
- Slide the gantry to one end and tighten the screws on the right side at that end.
- Slide the gantry to the other end, tighten the screws on the right side at that end.
Notes
- There are some small gaps above the rail and the linear rod. This is deliberate, since contact in this position would prevent the jig from sitting in the correct position.
- I don't have full detailed positional data for these jigs, but I've used sensible dimensions that I'm 99% sure are the target dimension for this assembly.
- Printing with just two perimeters and 10-15% infill should be fine.