UniFi USW-Flex-Mini Underdesk/Wall Mount (Print-in-Place)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Securely Mount Your USW-Flex-Mini with This Snug, No-Support 3D Printable Solution
- Ocena
- 5 / 5
- Polubienia
- 48
- Pobrania
- 447
- Wydruki
- 5
- Wyświetlenia
- 1377
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
It’ll be a cold day in hell before I waste my precious PLA on support material.
After countless iterations, I’ve nailed it—a snug, snap-fit under-desk mount for the Ubiquiti USW-Flex-Mini gigabit switch.
Prints in 37m51s on my P1S, using 20.37g of PLA with the settings below. Pshhh
This bad boy:
- prints in place
- no supports required
- optimized for a 4mm nozzle (six months later I spotted this typo)
- standard 2x perimeters
- set infill to off (or 5% if off makes you feel uncomfortable - infill truly isn't required)
- set “Ensure Vertical Shell Thickness” to “Critical Only”
- I used arachne wall generator - haven't tested with normal wall gen.
- I didn't need a brim on my bed, but your mileage might vary.
5mm screw holes.
There’s plenty of room for the included USB-C plug if you need it (and yes I know most printers could have easily bridged that gap, however I would rather be safe than sorry and went with a 45 degree gradient up to the bridge point)