Pistol Grip Pushup Bars
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Pushup bars with the ergonomics of a pistol grip
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 51
- Wydruki
- 0
- Wyświetlenia
- 230
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Indoor Sports
- Licencja
- GNU General Public License v3.0
These pushup bars are designed for good ergonomics while being minimal and easy to print. They should be printed with at least 4 walls and 5 layers top and bottom. Infill should be set at 40% (cubic or gyroid). They have been tested in ABS but they should be fine in PLA or PETG as long as you have good layer adhesion.
There is a version with supports built in that are connected with zipper tabs for quick removal. Just cut through the thin tabs with a hobby knife and then rip the supports off from the bottom up. A non-supported version is included if you would prefer slicer generated supports.
