Wera Tool-check plus slide tough case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 2 part sliding tough case for Wera toolcheck plus
- Ocena
- 0 / 5
- Polubienia
- 22
- Pobrania
- 134
- Wydruki
- 2
- Wyświetlenia
- 975
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
After making 2 of the supposedly rugged cases for this set (both ones I printed failed on the hinges) I decided to make a case with no hinges. Mine does not sit on my desk, it's used daily numerous times out in the field and is probably why the others failed.
This tough case is way stronger than the others by a huge amount. One part fits snugly into the other and the tool set itself is protect it's full length by the holder. I would recommend prining it in PLA+ or stronger if it's going to be used a lot in the field like mine is.
This works with my other model for the stop/slide which stops you losing parts.
Sadly there are 2 slight lines ( 1 on each side) and no matter what I do I can't remove them, tinkercad is a pain sometimes like that for leaving odd lines in models. I sunk the wera logo into each side. I used 3d-PrintThing's wera logo for ease (thank you). Though I didn't put this as a remix of his model as the whole model was designed by me apart from that.
I printed it with 15% infill. Print both part vertically, solid side down.