Surface Duo Keyboard Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A keyboard case for the surface duo.Requirements:Keyboard - https://www.adafruit.com/product/3601 (shop around,…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 604
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
A keyboard case for the surface duo.
Requirements: Keyboard - https://www.adafruit.com/product/3601 (shop around, there's other places that sell this) 5x 6mm M1.6 screws M1.6 threaded inserts 4x 30mm M2 hex cap screws A Microsoft Surface Duo Small snips of clear/translucent filament to plug the holes for the keyboard status LEDs - you can leave them just open but I quite like the softer diffused look that a small piece of cleaning filament gives me. You can set it in place just by holding a lighter beneath it for a couple of seconds to let it melt in place.
I don't check thingiverse much, so if you need help with this project then I am most easily contacted on Discord @ Zoemaestra#0119
Print Settings
Printer Brand:
Snapmaker
Printer:
Snapmaker 2 A250
Notes:
Any PLA will work.
Category: Electronics