Unifi Switch Lite 16 Poe Under Desk Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Unifi Switch Lite 16 Poe Under Desk Mount for mounting on the underside of your desk or a shelve.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 75
- Wydruki
- 1
- Wyświetlenia
- 375
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
So I had a Unifi Switch Lite 16 Poe, and needed to mount it on the bottom of the top of a cabinet (which contains all my hardware, like a NAS, RPi's, UPS, etc.) And since there was nog top mount available for the USW Lite 16 Poe, I used this model, and remixed it into this.
You need to print both models twice. Glue the 2 Part 2's to 1 Part 1, and mount it to where you want it. Then slide in the USW Lite 16 Poe, and then slide the second Part 1 over the front.
This way you can always take the front off, in case you need to remove the switch.
It will NOT fit the switch with the bottom towards the mounting holes, but since that will put the numbers upside down, that was not an issue for me.
Please leave a like if you enjoy this print!
Print instructions
I printed it with 3 top and bottom layers, with 3 walls and 20% infill (Cubic). And for me, that's strong enough. (Might differ with different materials). I printed it in PLA.
For part 1 you need supports for the overhang. I used tree supports, but normal supports should also work fine.