Parkside X20V charger PLG 20 C1 holder for IKEA SKADIS
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Allows mounting the charger vertically using the mounting holes it has. Has latches to keep everything in place.
- Ocena
- 5 / 5
- Polubienia
- 36
- Pobrania
- 303
- Wydruki
- 2
- Wyświetlenia
- 887
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
The charger has mounting holes, so this is a simple adapter between SKADIS and the holes. There are latches to keep the holder in the board and the charger in the holder, so pulling the battery out should not pull the charger out.
If you do need to remove the charger, it will likely at least partially pull out the holder from the board before it unlatches from the charger. So if you plan to remove it often (I don't), some tweaking of the relative resistances might be required. For that, the .scad file can be used.
I'd recommend printing from PETG and on the side, with supports for the hooks and pegs. This should result in the print being the strongest in the directions where it matters most. My .3mf is included too.