1 / 4
Parkside X20V charger PLG 20 C1 holder for IKEA SKADIS — image 1
1 / 4

Parkside X20V charger PLG 20 C1 holder for IKEA SKADIS

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Allows mounting the charger vertically using the mounting holes it has. Has latches to keep everything in place.

Rating
5 / 5
Likes
36
Downloads
303
Makes
2
Views
887
Reviews
2

Updated at source:

Model information

Category
Organizers
License
Creative Commons — Attribution — Share Alike

The charger has mounting holes, so this is a simple adapter between SKADIS and the holes. There are latches to keep the holder in the board and the charger in the holder, so pulling the battery out should not pull the charger out.

If you do need to remove the charger, it will likely at least partially pull out the holder from the board before it unlatches from the charger. So if you plan to remove it often (I don't), some tweaking of the relative resistances might be required. For that, the .scad file can be used.

I'd recommend printing from PETG and on the side, with supports for the hooks and pegs. This should result in the print being the strongest in the directions where it matters most. My .3mf is included too.