Li'l Magnum! Fingertip Mouse Shell for VXE Mad R (16 grams)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is inspired by Optimum Tech's Zeromouse and Zeromouse Blade, but using FDM and a more affordable donor mouse.
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 265
- Wydruki
- 1
- Wyświetlenia
- 2121
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is obviously inspired by Optimum Tech's Zeromouse and Zeromouse Blade, but using FDM and a more affordable donor mouse.
The thumb and finger rests are in a reasonable spot for me, and the buttons are lined up well. The shell requires A LOT of bending and finagling of the button paddles to get the donor PCB installed.
The model is parametric, but it needs cleaning up. I want to make it easy to adjust the offsets of the finger grabbies, but it is too messy for that so far. I will post the OpenSCAD after I get it cleaned up.
My setup printed in PLA comes in at 16.43 grams with the VXE Mad R electronics.
The button flapper paddles have less spring tension when printed with one perimeter instead of two, and the length of the plunger has been adjusted to make up for this. I am using lightning infill, and I had to lower the “minimum sparse infill threshold” in Orcaslicer to 1 cubic mm to make sure the button arms would be hollow. The width and thickness of the arms is dialed in for the springiness of PLA.
I do not have a Mad R Major to test, but it looks like it should fit just fine.
- v2.0 - Initial release of the Li'l Magnum for the VXE Mad R
- v2.1 - Add support pillar and strong connectors to keep left button from flexing the PCB
- Li'l Magnum! shell for the VXE Dragonfly R1 Pro / Pro Max
- Li'l Magnum! shell for the VXE Dragonfly R1 / R1 SE / R1 SE+
- Li'l Magnum! Fingertip Mouse Shell for MCHOSE L7 Ultra