Li'l Magnum! Fingertip Mouse Shell for VXE Mad R (16 grams)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is inspired by Optimum Tech's Zeromouse and Zeromouse Blade, but using FDM and a more affordable donor mouse.
- Rating
- 0 / 5
- Likes
- 16
- Downloads
- 265
- Makes
- 1
- Views
- 2,121
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Video Games
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is obviously inspired by Optimum Tech's Zeromouse and Zeromouse Blade, but using FDM and a more affordable donor mouse.
The thumb and finger rests are in a reasonable spot for me, and the buttons are lined up well. The shell requires A LOT of bending and finagling of the button paddles to get the donor PCB installed.
The model is parametric, but it needs cleaning up. I want to make it easy to adjust the offsets of the finger grabbies, but it is too messy for that so far. I will post the OpenSCAD after I get it cleaned up.
My setup printed in PLA comes in at 16.43 grams with the VXE Mad R electronics.
The button flapper paddles have less spring tension when printed with one perimeter instead of two, and the length of the plunger has been adjusted to make up for this. I am using lightning infill, and I had to lower the “minimum sparse infill threshold” in Orcaslicer to 1 cubic mm to make sure the button arms would be hollow. The width and thickness of the arms is dialed in for the springiness of PLA.
I do not have a Mad R Major to test, but it looks like it should fit just fine.
- v2.0 - Initial release of the Li'l Magnum for the VXE Mad R
- v2.1 - Add support pillar and strong connectors to keep left button from flexing the PCB
- Li'l Magnum! shell for the VXE Dragonfly R1 Pro / Pro Max
- Li'l Magnum! shell for the VXE Dragonfly R1 / R1 SE / R1 SE+
- Li'l Magnum! Fingertip Mouse Shell for MCHOSE L7 Ultra