1 / 17
Benchski - remixed 3DBenchy - extreme test of nearly impossible overhangs — zdjęcie 1
1 / 17

Benchski - remixed 3DBenchy - extreme test of nearly impossible overhangs

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

If yours can do the steep overhangs at fronts of the skis, without any noticeable sag, then you have one amazing printer

Ocena
0 / 5
Polubienia
25
Pobrania
44
Wydruki
0
Wyświetlenia
340
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Test Models
Licencja
Creative Commons — Attribution — Share Alike

If your printer can do the steep overhangs at the fronts of the skis, without any noticeable sag, then you have one amazing printer.

I'm including a couple of OrcaSlicer .3mf files. See below for more details.

I did two prints in PLA: one at 0.28 mm layer height, and another at 0.12 mm layer height. Obviously the appearance and aesthetic quality was better on the second print with the thinner layer height — it was more than twice as many layers and took more than twice as much time (1 hour and 7 minutes compared to 35 minutes for the thick layer height). 

Both prints were done on a standard, stock Flashforge Adventurer 5M, a fast CoreXY machine, of which I have three. If you are interested in one, here's an affiliate link: https://amzn.to/3DoF6at .

The prints were made using their stock 0.4 mm nozzle, and using an OrcaSlicer print profile provided by Flashforge, with essentially only one change: the layer height was first increased from 0.2 mm to 0.28 mm, and then decreased to 0.12 mm. Also, I did literally no post processing of the resulting print — I did not even remove little wisps from where the nozzle retracted, etc. 

This first batch of attached photos is the 0.28 mm layer height:

This second batch of attached photos is the 0.12 mm layer height:

Change log:

  • February 27, 2025 - moved the center ski forward a bit, as it was interfering with one of the letters on the bottom of the boat.
  • February 27, 2025 - initial upload