Fractal North Pi Case - with rear IO adapter and NVMe SSD for Raspberry Pi 5
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3D Printed Case for Raspberry Pi 5 which allows you to use an NVMe SSD Shield with a Rear IO Adapter.
- Ocena
- 5 / 5
- Polubienia
- 61
- Pobrania
- 268
- Wydruki
- 5
- Wyświetlenia
- 3205
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This case allows you to use your Raspberry Pi 5 together with the Geekworm X1001 NVMe SSD hat and the Waveshare rear IO adapter with full size HDMI ports.
Most of the parts should be interchangeable to the model by JoKneeMo. Just some small differences in tolerances and some additional chamfers, fillets etc. However, if you use the main body of this part, you also have to use the solid side panel, since I shortened both of them by 6mm. Also the front piece where the wooden strips attaches is slightly different. But you can use the original front piece with printed strips as well.
You can also find the assembly with all parts of the case attached as a step file. However, since most of the parts were just converted STL-files, working with them is a bit tricky. Since the Raspberry Pi model and rear IO-Shield are very detailed, I removed them, but you can find models of them online.
The version I printed has an additional button at the top to turn the Raspberry Pi on and off, but since this uses a custom PCB I decided to not include this in the STL-files.
I added an additional 40x10mm fan to the front. I decided to use a 12V fan and connect it to the 5V “input” of the NVMe hat. This means that the fan runs at a very low speed and is very quiet. However, not all 12V fans will be able to spin at such a low voltage.
For assembly you need 17* M2.5x4mm heat set inserts, 9* M2.5x6 or x8mm countersunk screws and 8* M2.5x6 or 8mm cylinder head screws. Also you need to replace the 3* female-to-female brass standoffs of the NVMe hat with 3* male-to-female standoffs with a length of 17-20mm