Keyboard Riser - Cherry DW8000
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Hi,
I designed this keyboard riser for my work keyboard. I didn't like the angle of the bare keyboard and I was always looking for my pens. This design solved my problems and it allready found liking with some work mates.
notes:
- simple clip/snap assembly, no glueing
- 2 versions >> single & dual pen holder
- one round insert to reduce the inner diameter of the pen holder for thinner pens
penholder assembly:
Attach the penholder to the clamp as shown in the next to last picture, then rotate the holder ~90° counter clockwise until it snaps in. Do it slowly and with a bit of caution. I printed 6 sets for me and my work mates in PLA+ … none broke so far.
my print settings:
- filament = Elegoo Rapid PLA+ black
- 0,2 mm layer height @ 0,4 nozzle
- 3 perimeters
- 10% gyroid infill
- solid layer: 3 top & bot
- supports: no
- print orientation as in the picture
Happy printing.