ARKSEN Roof Rack Side Light Mounts (Camp Lights)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Arksen Roof Rack Camping Light MountNeeded Parts- Roof Rack https://a.co/d/6j8anHo - Flood Lights…
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 232
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Share Alike
Arksen Roof Rack Camping Light Mount
Needed Parts
- Roof Rack https://a.co/d/6j8anHo
- Flood Lights https://a.co/d/cig1wV4
This model was designed to clip into place where the normal metal support plates are on the Arksen roof rack. After removing the metal plates then you can snap these into place and reinsert the screw from the top and bottom. Then just bolt the light onto the track and adjust it up or down to the angle you need.
I highly recommend printing this in ASA due to its high temperature resistance and UV resistance. I printed these all on a Bambu Labs P1S with about 25% infill.
After installing the mount I ran one ground wire up to both lights and a separate power wire to each side of the roof rack. This allows you to turn on one side or both.
Print Settings
Filament Material:
ASA
Category: 3D Printing