1 / 8
Dell Optiplex 5070 with Keystone Port for 10" inch rack — zdjęcie 1
1 / 8

Dell Optiplex 5070 with Keystone Port for 10" inch rack

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Dell Optiplex 5070 with Keystone Port for 10" inch rack

Ocena
4,6 / 5
Polubienia
65
Pobrania
457
Wydruki
5
Wyświetlenia
4636
Oceny
5

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

10" Rack tray to hold a Dell Optiplex 5070 (although other Optiplex models should fit) but also with an option to add a keystone jack (see my other models if you want to test print the same port to test).

** NOTE: These Rack components were designed to fit a HOME MADE rack using rack rails and my supports to build a home made rack, therefore they may not fit your own store bought rack if you went down that path without a little modification - please check before printing.  The designs are 250mm wide with a space between the upright rails being 220mm.  Although some models within the range are slightly less than the 220mm.  Please check before printing.

There is a small block at the rear of the tray to stop the device moving backwards in the tray and the feet can remain in place due to cutouts for them.

 

I've printed mine in PETG Galaxy Black for the top one in the rack picture and PETG Jet Black for the lower one (I ordered the wrong extra spool!) - With regards print settings : I amended print to have no skirt to fit on the plate (but you could print diagonally on the plate) and also used Organic supports.  Everything else was left at default settings.

Tagi