Custom Backing for Hexagon Wall Shelf - Funko Pop
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A quick and easy to print custom backing design for the Hexagon Wall Shelf Funko Pop created by: HvacDad
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 214
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Youtube playback keeps defaulting to low quality. Please manually select 1440p when watching.
A quick and easy to print custom backing design for the Hexagon Wall Shelf Funko Pop created by: HvacDad
https://makerworld.com/en/models/616662?from=search#profileId-540282
(I was not able to find this particular print here on Printables)
I have tested this a good bit with various prototypes and this is the final version. the backing itself is quite thin as to use as less filament as possible, but is durable enough to last.
I have integrated a cover for the screw part which should have enough clearance for any of the shelves that have screws or nails in them.
The backing is designed with a tight but not too tight fit as to make it easy to insert while the shelves are on the the wall I have additionally added two tiny handles on either side of the backing to make it dead easy to take out.
The screw cover part should be enough to hold it in place but I have added a small “lip” at the very bottom to help prevent the backing from falling over, this lip will also ensure that the backing dose not fall behind the shelf unit too.
PLEASE NOTE: some supports are required for the screw cover part but these should be removable very easily
As this is my very first upload of a 3D print design I hope that it is suitable, but please let me know if there are any problems with this as so I can try make additional modifications to it.
Would like to say a big thanks to https://www.printables.com/@anthroterrie for helping test this, her wonderful photo and general help with my first experiences with 3d printing.