Induction Coil/Heater Sterilizer (No Soldering required)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A quick remix I made of Myco Dogs induction sterilizer case. A few small changes that improved the model for what I need
- Ocena
- 5 / 5
- Polubienia
- 20
- Pobrania
- 117
- Wydruki
- 2
- Wyświetlenia
- 582
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Remix of Myco Dogs model. I changed it up a bit to better suit what I wanted. Parts and affiliate links can be found on the original model.
Print with both flat sides down with no supports. I used 15% infill with PLA+, but any filament should work fine.
I've included three variants of the base and lid models. Solder, No solder, and a hybrid. The hybrid will work with either the solder or the screw-in terminals. Then each of the lid models have an option for a button or without a button.
You will need:
Induction heater - https://amzn.to/4jDFq4d
5.5 x 2.1 Jack Plug - https://amzn.to/4jHXL04
12v 5A/10A power supply (10A preferred) - https://amzn.to/4kBzbiE
Either a foot switch or push button - https://amzn.to/3HB1oYi
Four 12mm M3 bolts (Optionally, you can use the heater to heat a piece of metal and plastic weld the two halves together, which is what I did as a temporary solution)
List of changes from original model:
Removed text from the case
Made three different variants
Changed the hole(s) for the coil so that you can use the screw fasteners, which means no soldering required