1 / 2
Glue Dispenser for Würth MAK38 MethylMethacrylate glue — zdjęcie 1
1 / 2

Glue Dispenser for Würth MAK38 MethylMethacrylate glue

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Manual dispenser for a MMA glue, that needs a dispenser gun and mixing tip. Just lock insert the glue,pilot and squeeze!

Ocena
0 / 5
Polubienia
1
Pobrania
18
Wydruki
0
Wyświetlenia
151
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
GNU General Public License v3.0

Very strong and expensive glue. But to use them you need even pricier dispenser so I designed a little jig, to push the glue out from both tubes close to exactly same amount Part A and Part B

You dont necessarily need mixing tip, just squeeze it in a small container and mix very well (when you think youre done, mix it some more)

 

Print Settings

Best to use PLA due to low shrinking koeficient.

Pistons are quite a tight fit so you dont squeeze too much from one tube.

My settings were:

PLA

3 perimeters

15% gyroid infill

But it is material and settings independent. 

Prints without supports

Tagi