1 / 2
Glue Dispenser for Würth MAK38 MethylMethacrylate glue — image 1
1 / 2

Glue Dispenser for Würth MAK38 MethylMethacrylate glue

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Manual dispenser for a MMA glue, that needs a dispenser gun and mixing tip. Just lock insert the glue,pilot and squeeze!

Rating
0 / 5
Likes
1
Downloads
18
Makes
0
Views
150
Reviews
0

Updated at source:

Model information

Category
Tools
License
GNU General Public License v3.0

Very strong and expensive glue. But to use them you need even pricier dispenser so I designed a little jig, to push the glue out from both tubes close to exactly same amount Part A and Part B

You dont necessarily need mixing tip, just squeeze it in a small container and mix very well (when you think youre done, mix it some more)

 

Print Settings

Best to use PLA due to low shrinking koeficient.

Pistons are quite a tight fit so you dont squeeze too much from one tube.

My settings were:

PLA

3 perimeters

15% gyroid infill

But it is material and settings independent. 

Prints without supports

Tags