Club Mace for cosplay
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A long handled club mace I designed that could be used for cosplay..
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 90
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Attribution — Share Alike
So I got bored and wanted to see how difficult it would be to design a ‘modular’ mace (and I always kinda wanted one)
It turns out, not that difficult to be honest.
So, I printed it, painted it and now its on the wall at home along with my war hammer.
It's designed for a 2.5cm/25mm diameter handle - Adjust the length to your preference - I made mine around 60cm/600mm.
The tolerances are pretty tight, so you might need to sand them down ever so slightly but it all fits together quite well.
Print 4 x Teeth.
Print 1 x Everything else.
25% infill / 0.4
Designed in Tinkercad.
Printed on a Flashforge Adventurer 5M.
Note:
If you're intended on actually hitting people with this, then I strongly recommend you print the teeth in TPU because those teeth are SHARP.
Seriously, be careful.
Otherwise, Enjoy!