Bike Phone Holder / Mount V2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An actually usable 3D printed phone holder for your bike
- Ocena
- 5 / 5
- Polubienia
- 196
- Pobrania
- 1412
- Wydruki
- 10
- Wyświetlenia
- 4179
- Oceny
- 11
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Share Alike
Please, share your feedback if you like this model
DESCRIPTION (IMPORTANT!):
Designed to fit standard 31.8mm (1.25") diameter MTB handlebars, 25.4mm (1") spacer included in the archive. For 22mm, check out the remix by moWerk, and Shaun577's remix for 35mm handlebars.
Can hold 65-85mm wide and up to 10mm thick phones. (Pretty much all phone models are in this range).
Pay attention to your handlebar stem sizes. In my case there's plenty of room, but it might be too thick to fit on some bikes.
PROS:
Free and Open Source design.
Fully 3D printable (No screws, glue, etc.),
Center mounting,
Horizontal orientation,
Access to all ports and buttons,
Strong grip on both the phone and the handlebar,
Easy to print/assemble/use, no supports/rafts/brims are required, no bridges or extreme overhangs.
PRINT SETTINGS:
PETG is recommended for better toughness and impact resistance.
Layer height of 0.12mm is optimal, increasing it will negatively affect parts fitting.
3+ Wall loops. (Or you'll end up smashing your phone)
Enable “Precise wall”, “Arc Fitting” and “Aligned Seam”, if available in your slicer.
Do not use supports, rafts or brims.
The “All in One” model fits on a 15x15cm bed.
Check the archive for individual STLs.
ASSEMBLY GUIDE:
