Tri wick holder for a 110mm jar
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I am the original creator of the first file for a 100mm jar. Was asked if it could be edited to fit a 110mm jar.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 68
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The ring is designed to fit over the top of a 110mm glass candle jar, as requested by a member of this website, and provides 3 locations to place and secure wicks located on a set radius from the center and an additional center location in the event a single wick candle was being made.
The holes for the wicks are slightly oversized to allow slightly frayed and unraveled wick ends to pass through and each hole has built in wick retention via tapered channels off-shooting from the holes.